JMR electronic PUB-00281 Manuel d'utilisateur télécharger pdf (Page 19)

External I/O Connection

The external I/O connections are located on the personality card There are four

SFP tranceiver connectors accessible from the rear of the unit.

CH-A and CH-B (Top)

Input and output connections for Loop 1. These are SFP (2Gb/s) transceiver

connectors used to connect to a host system or to an expansion chassis.

CH-A and CH-B (Bottom)

Input and output connections for Loop 2. These are SFP (2Gb/s) transceiver

connectors used to connect to a host system or to an expansion chassis.

System/SES Fault LED & Audible Alert

This red LED will light along with a buzzer if a system fault occurs. A system

fault includes over temperature, power fault, or blower fault. The buzzer will

sound off with a sequence of beeps to indicate the fault that has occurred.

2 beeps = Temperature Fault

3 beeps = Blower Fault

5 beeps = Power Supply Fault

The light will stay on red if a fault occurs. During normal operation, the red light

will blink to notify that internal SES monitoring is working.

FORTRA



FORCE

G15 & G15+ RAID System Installation Guide Rev A

4-5

Mute

CH-B

CH-A

0-7 ID

Switch

0-15 ID

Switch

0-15 ID

Switch

0-7 ID

Switch

CH-A

CH-B

SES-ACT

SYS-

FAULT

SYS-

FAULT

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 32 33

Pas de commentaire

JMR electronic PUB-00281 Manuel d'utilisateur Page 19